REQUEST FORM / Multi-roller burnishing tool

 


Contact details


Application


Requirements


Which surface quality is to be achieved?


Which surface quality can be achieved in the preprocess?




 

NOTE:

  1. It is not possible to roll up to the bottom of the hole/shoulder.
  2. Please observe dimension "X" (see illustration). This area cannot be rolled!
  3. When setting the tool diameter above the nominal size of the tool then the taper will overlap the cage. Therefore the dimension “X” (see overleaf) will increase. This increase will be About 0.2 mm per 0.01 mm Diameter enlargement ( = one mark on the tool scale) of the tool setting.

 


Which pre-processing method is used before roller burnishing?


Are there any other requirements for the tool? If yes, please fill out:


Which coolant is used?

Internal coolant required?